The main reason for failure of water purificatioequipment

2020-06-23 18:25 来源:未知

  The main reason for substandard water purification equipment Time: 2019-01-02 15:26:14 water reverse osmosis water production equipment failure most of improper maintenance, improper operation, failure of supplies and parts failures, aging and other causes, so we first need to make sure whether it is because of system failure, caused by aging parts, if the device works well but the water production failed, most likely because the reverse osmosis membrane performance degradation caused by raw water quality changes, leading to poor pretreatment effect, the reverse osmosis membrane water quality is not up dirt on the film will cause the block. The main quality issues: (1) the machine does not meet health and safety standards. 35 batches of water purification of the project failed, mainly because some manufacturers use the health and safety of substandard materials and components in contact with water, the water purifier key information rinse time, water and other products deletion description. (2) The total net amount of water does not meet standards. Nine batches of the project failed, mainly because some manufacturers use the low quality water filters, resulting in a total net amount of water nominal range of business, water purifiers and water quality pollutants (heavy metals , organic matter and microorganisms) removal of non-compliance. (3) the power cable and the outer cord does not meet standards. Six batches of the project failed, mainly due to the power line cross-sectional area some manufacturers use up to standard requirements. Use of a prolonged overload will cause the heating body line, cracking insulation aging, the occurrence of leakage and other accidents. (4) Input power and current standards do not meet the requirements. There are two batches of the project failed, mainly because some manufacturers of household water purifiers vacuity of rated power. If consumers use the power outlet capacity is too small outlet capacity can not meet the requirements, it will cause fever overload. Reverse osmosis water equipment: reverse osmosis water caused by substandard water production equipment, most of improper maintenance, improper operation, failure of supplies and parts failures, aging and other reasons, we first need to make sure whether it is because of system failure, caused by aging parts If the device works well but the water production failed, most likely because the reverse osmosis membrane performance degradation caused by raw water quality changes, leading to poor pretreatment effect, the water quality is not up to the reverse osmosis membrane, the membrane will pollution caused by blocked, causing the membrane performance. At this time we have taken measures to solve the reverse osmosis membrane is clean, if pollution is a serious need to be replaced. RO membrane fouling reverse osmosis water can be said to cause water production apparatus does notQualified important factor, specific membrane fouling water purification equipment how to do, you can refer to the appropriate information, the right to solve the problem, do not blindly operate so as to avoid greater losses.

TAG标签: Service supp
版权声明:本文由Qinyuan water purifier发布于Service support,转载请注明出处:The main reason for failure of water purificatioequipment